Auth-1028; Auth-1029 - Brocade Communications Systems SN3000B Reference

5

AUTH-1028

Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1028
Message
<timestamp>, [AUTH-1028], <sequence-number>,, ERROR, <system-name>, Failed to
allocate <data type> for <operation phase>: port <port number>.
Probable Cause Indicates that the authentication process failed because the system is low on memory.
Data type is the payload or structure that failed to get memory. Operation phase specifies which
operation of a particular authentication phase failed.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1029

Message
<timestamp>, [AUTH-1029], <sequence-number>,, ERROR, <system-name>, Failed to get
<data type> for <message phase> message: port <port number>, retval <error code>.
Probable Cause Indicates that the authentication process failed to get a particular authentication value at certain
phase.
Data type is the payload or structure that failed to get memory.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
62 Fabric OS Message Reference
53-1002448-01