Fw-1054; Fw-1113; Fw-1114 - Brocade Communications Systems SN3000B Reference

45

FW-1054

FW-1054
Message
<timestamp>, [FW-1054], <sequence-number>,, WARNING, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) Power on Hours has risen above
the high boundary. High value indicate the SFP's maximum lifetime of use.
Recommended Replace the SFP.
Action
Severity WARNING

FW-1113

Message
<timestamp>, [FW-1113], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the number of times E_Ports have gone down has changed. E_Ports go down each
time you remove a cable or small form-factor pluggable (SFP). SFP failures also cause E_Ports to go
down. E_Port downs might be caused by transient errors.
Recommended Check both ends of the physical connection and verify that the SFPs and cables are functioning
Action properly.
Severity INFO

FW-1114

Message
<timestamp>, [FW-1114], <sequence-number>,, INFO, <system-name>, <Label>, is
below low boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the number of times E_Ports have gone down has fallen below the low boundary.
E_Ports go down each time you remove a cable or small form-factor pluggable (SFP). SFP failures
also cause E_Ports to go down. E_Port downs might be caused by transient errors. A low number of
E_Port failures means that the switch is functioning normally.
Recommended No action is required. Respond to this message as is appropriate to the particular policy of the
Action end-user installation.
Severity INFO
350 Fabric OS Message Reference
53-1002448-01