Bm-1004; Bm-1005; Bm-1006 - Brocade Communications Systems SN3000B Reference

10

BM-1004

Recommended Use the slotPowerOff and slotPowerOn commands or reseat the affected blade.
Action
Severity WARNING
BM-1004
Message
<timestamp>, [BM-1004], <sequence-number>,, INFO, <system-name>, Blade firmware
<Blade firmware> on slot <Slot> is not consistent with system firmware <System
firmware>. Auto-leveling blade firmware to match system firmware.
Probable Cause Indicates the policy of the specified blade is to auto-level the blade firmware to the system
firmware. The reason for the inconsistency may be due to either of the following reasons:
•
•
Recommended No action is required. The blade will automatically download the updated firmware.
Action
Severity INFO

BM-1005

Message
<timestamp>, [BM-1005], <sequence-number>,, WARNING, <system-name>,
Firmwaredownload timed-out for blade in slot <Slot>. Faulting blade.
Probable Cause Indicates the firmwareDownload command failed for the blade in the specified slot.
Recommended Use the slotPowerOff and slotPowerOn commands or reseat the affected blade. On the Brocade
Action 7500 or 7600, switch off and switch on all primary power to power-cycle the unit.
Severity WARNING

BM-1006

Message
<timestamp>, [BM-1006], <sequence-number>,, INFO, <system-name>, Blade is not
configured. Persistently disabling all ports for blade in slot <Slot number>
Probable Cause Indicates the policy of the specified blade is set to persistently disable all ports the first time the
blade is detected. The message indicates either of the following:
•
•
Recommended Configure the blade so that it will persistently enable the ports.
Action
Severity INFO
92
Blade firmware was detected to be different from the control processor (CP) firmware due to a
firmware upgrade.
The blade was just inserted and had a different version of the firmware loaded.
The blade was detected in this slot for the first time.
The blade was configured under a different mode.
.
Fabric OS Message Reference
53-1002448-01