Sulb-1020; Sulb-1021; Sulb-1023 - Brocade Communications Systems SN3000B Reference

Recommended Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and
Action slotPowerOn commands to trigger another firmwareDownload. If the blade is stuck in LOADING
state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists,
contact your switch service provider.
Severity ERROR

SULB-1020

Message
<Sequence Number> AUDIT, <timestamp>, [SULB-1020], ERROR, FIRMWARE,
<event-initiator-details>, <event-location>, , New firmware failed to boot in slot
<Slot number>
Probable Cause Indicates the BP blade should restart with the new image, but is still running the old image. This
error may indicate that the new image has not been loaded correctly to the specified blade.
Recommended Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and
Action slotPowerOn commands to trigger another firmwareDownload to the blade. If the blade is stuck in
LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem
persists, contact your switch service provider.
Severity ERROR

SULB-1021

Message
<Sequence Number> AUDIT, <timestamp>, [SULB-1021], WARNING, FIRMWARE,
<event-initiator-details>, <event-location>, , Firmware is being downloaded to
the blade in slot <Slot number>.
Probable Cause Indicates the firmware is being loaded to the specified blade.
Recommended Run the firmwareDownloadStatus command to monitor the firmwareDownload progress. After it
Action finishes, run the firmwareShow command to verify the firmware versions.
Severity WARNING

SULB-1023

Message
<Sequence Number> AUDIT, <timestamp>, [SULB-1023], WARNING, FIRMWARE,
<event-initiator-details>, <event-location>, , The blade in slot
has rebooted during firmwaredownload.
Probable Cause Indicates there may be an error caused by an unexpected disruption of the firmwareDownload
command, for example, by powering off and on of the indicated BP blade in the middle of a
firmwareDownload. The error may also be caused by persistent storage hardware failure or by a
software error.
Fabric OS Message Reference
53-1002448-01
.
137
SULB-1020
<Slot number>
861