C3-1001; C3-1002; C3-1004; C3 System Messages - Brocade Communications Systems SN3000B Reference

C3 System Messages

C3-1001

Message
<timestamp>, [C3-1001], <sequence-number>,, ERROR, <system-name>, Port <port
number> failed due to SFP validation failure. Check if the SFP is valid for the
configuration.
Probable Cause Indicates a deteriorated small form-factor pluggable (SFP), an incompatible SFP pair, or a faulty
cable between the peer ports.
Recommended Verify that compatible SFPs are used on the peer ports, the SFPs have not deteriorated, and the
Action Fibre Channel cable is not faulty. Replace SFPs or cable if necessary.
Severity ERROR

C3-1002

Message
<timestamp>, [C3-1002], <sequence-number>, FFDC, ERROR, <system-name>, Port <port
number> chip failed due to an internal error.
Probable Cause Indicates an internal error. All the ports on the blade or switch will be disrupted.
Recommended To recover a bladed system, execute the slotPowerOff and slotPowerOn commands on the blade. To
Action recover a non-bladed system, execute the fastboot command on the switch.
Severity ERROR

C3-1004

Message
<timestamp>, [C3-1004], <sequence-number>,, ERROR, <system-name>, S<slot
number>,C<chip index>: Invalid DMA ch pointer, chan:<Channel number>,
good_addr:0x<Good address> bad_addr:0x<Bad address>.
Probable Cause Indicates an internal error in the Application-Specific Integrated Circuit (ASIC) hardware that may
degrade data traffic.
Recommended Whenever this error is observed, reboot the system at the next maintenance window. If the problem
Action persists, replace the blade.
Severity ERROR
Fabric OS Message Reference
53-1002448-01
Chapter
12
103