Sec-1044; Sec-1045; Sec-1046 - Brocade Communications Systems SN3000B Reference

94

SEC-1044

Recommended Use valid syntax when entering port ranges.
Action
Severity ERROR
SEC-1044
Message
<timestamp>, [SEC-1044], <sequence-number>,, ERROR, <system-name>, Duplicate
member <member ID> in (<List>).
Probable Cause Indicates the specified member is a duplicate in the input list. The list can be a policy list or a
switch member list.
Recommended Do not specify any duplicates.
Action
Severity ERROR

SEC-1045

Message
<timestamp>, [SEC-1045], <sequence-number>,, ERROR, <system-name>, Too many port
members.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1046

Message
<timestamp>, [SEC-1046], <sequence-number>,, ERROR, <system-name>, Empty list.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
588 Fabric OS Message Reference
53-1002448-01