Fcr-1071; Fcr-1072; Fcr-1073; Fcr-1074 - Brocade Communications Systems SN3000B Reference

FCR-1071

Message
<timestamp>, [FCR-1071], <sequence-number>,, INFO, <system-name>, Port <port
number> is changed from non FCR port to FCR port.
Probable Cause Indicates that the port became an EX_Port or VEX_Port.
Recommended No action is required.
Action
Severity INFO

FCR-1072

Message
<timestamp>, [FCR-1072], <sequence-number>,, INFO, <system-name>, Port <port
number> is changed from FCR port to non FCR port.
Probable Cause Indicates that the port is no longer an EX_Port or VEX_Port.
Recommended No action is required.
Action
Severity INFO

FCR-1073

Message
<timestamp>, [FCR-1073], <sequence-number>,, INFO, <system-name>, Switch with
domain ID <domain ID> in fabric <fabric ID> has lower limit of LSAN Zones
supported.
Probable Cause Indicates that an earlier version of the switch in the backbone or edge that supports a different
limit of logical storage area network (LSAN) zones was detected.
Recommended Use the fcrResourceShow command on all Fibre Channel Routers in the Meta-SAN to find the
Action lowest supported LSAN zone limits. Ensure that total number of LSAN zones in the Meta-SAN are
within the lowest supported limit of LSAN zones.
Severity INFO

FCR-1074

Message
<timestamp>, [FCR-1074], <sequence-number>,, ERROR, <system-name>, HA sync lost
as remote CP supports only <LSAN count> LSAN Zones.
Probable Cause Indicates that the remote control processor (CP) has older firmware, which only supports a lower
number of logical storage area network (LSAN) zones. This is causing the loss of the
high-availability (HA) sync.
Fabric OS Message Reference
53-1002448-01
37
FCR-1071
271