Hil-1501; Hil-1502; Hil-1503 - Brocade Communications Systems SN3000B Reference

48

HIL-1501

Recommended Install the missing fan FRUs immediately.
Action
Severity WARNING
HIL-1501
Message
<timestamp>, [HIL-1501], <sequence-number>,, WARNING, <system-name>, Slot <slot
number>, high temperature (<measured temperature>).
Probable Cause Indicates that the temperature of this blade has risen above the warning threshold.
Recommended Run the fanShow command to verify all the fans are working properly.
Action
Make sure that the area is well-ventilated and that the room temperature is within operational
range of your switch. Refer to the hardware reference manual for your switch for the operational
temperature range.
Severity WARNING

HIL-1502

Message
<timestamp>, [HIL-1502], <sequence-number>, FFDC, CRITICAL, <system-name>, Slot
<slot number>, high temperature (<measured temperature>). Unit will be shut down
in 2 minutes if temperature remains high.
Probable Cause Indicates that the temperature of this blade has risen above the critical threshold. This usually
follows a high-temperature message.
Recommended Run the fanShow command to verify all the fans are working properly.
Action
Make sure that the area is well-ventilated and that the room temperature is within operational
range of your switch. Refer to the hardware reference manual for your switch for the operational
temperature range.
If the message persists, replace the blade.
Severity CRITICAL

HIL-1503

Message
<timestamp>, [HIL-1503], <sequence-number>, FFDC, CRITICAL, <system-name>, Slot
<
slot number
Probable Cause Indicates that the temperature of this blade has been above the maximum threshold for at least
two minutes. The blade is shut down to prevent damage. This usually follows a high-temperature
warning message.
Recommended Run the fanShow command to verify all the fans are working properly.
Action
438
>
, unit shutting down.
Fabric OS Message Reference
53-1002448-01