Zone-1018; Zone-1019 - Brocade Communications Systems SN3000B Reference

Recommended Edit the zone database to make sure that only one initiator is set for each FA zone configuration.
Action
Severity ERROR

ZONE-1018

Message
<timestamp>, [ZONE-1018], <sequence-number>,, ERROR, <system-name>, Incorrect
zoning enforcement type(<zone type>) at port(<port number>).
Probable Cause Indicates that an incorrect zoning enforcement type was reported on the specified port. This is a
software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The
following are the valid zone type values:
•
•
•
•
QuickLoop zones are not supported in Fabric OS version 4.x or later.
Recommended If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
Action transfers; then execute the supportSave command and contact your switch service provider.
Severity ERROR

ZONE-1019

Message
<timestamp>, [ZONE-1019], <sequence-number>,, ERROR, <system-name>, Transaction
Commit failed. Reason code <reason code> (<Application reason>) - \"<reason
string>\"
Probable Cause Indicates that reliable commit service (RCS) had a transmit error. RCS is a protocol used to transmit
changes to the configuration database within a fabric.
Recommended Often this message indicates a transitory problem. Wait a few minutes and retry the command.
Action
Make sure your changes to the zone database are not overwriting the work of another
administrator.
Execute the cfgTransShow command to determine if there is any outstanding transaction running
on the local switches.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Severity ERROR
Fabric OS Message Reference
53-1002448-01
1 - Hard port zone
2 - Hard wwn zone
3 - Session-based hard zoning
5 - FA zone
115
ZONE-1018
757