Swch-1014; Swch-1015; Swch-1016; Swch-1017 - Brocade Communications Systems SN3000B Reference

SWCH-1014

Message
<timestamp>, [SWCH-1014], <sequence-number>,, INFO, <system-name>, All Trunk
Areas have been disabled.
Probable Cause Indicates that all Trunk Areas have been disabled and the configuration file has been updated.
Recommended No action is required.
Action
Severity INFO

SWCH-1015

Message
<timestamp>, [SWCH-1015], <sequence-number>,, WARNING, <system-name>, <Function
name> <Description of problem>.
Probable Cause Indicates that an internal problem has been detected by the software. This is usually an internal
Fabric OS problem or due to file corruption.
Recommended Restart or power cycle the switch
Action
If the message persists, run the firmwareDownload command to update the firmware.
Severity WARNING

SWCH-1016

Message
<timestamp>, [SWCH-1016], <sequence-number>,, INFO, <system-name>, Device <wwn
name of device>fdiscs to port <port number>. Static persistent PID set and area
requested not assigned to the device. Reject FDISC.
Probable Cause Indicates static persistent PID is set and the area requested is not assigned to the device.
Recommended This is a NPIV device and static peristent PID is set on it, we are not able to assign the area
Action requested. Remove the static binding to have the device come up with a different area and run the
wwnaddress
Severity INFO

SWCH-1017

Message
<timestamp>, [SWCH-1017], <sequence-number>,, INFO, <system-name>, Device <wwn
name of device> tries to flogi to port <port number>, reject FLOGI as persistent
PID is set on the Loop device.
Probable Cause Indicates persistent PID is set and static Persistent PID is not supported on the Loop device.
Fabric OS Message Reference
53-1002448-01
unbind wwn command.
--
102
SWCH-1014
711