Zone-1030; Zone-1031; Zone-1032 - Brocade Communications Systems SN3000B Reference

115

ZONE-1030

Recommended If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
Action transfers; then execute the supportSave command and contact your switch service provider.
Severity WARNING
ZONE-1030
Message
<timestamp>, [ZONE-1030], <sequence-number>,, WARNING, <system-name>, Converting
the zone db for PID format change failed.
Probable Cause Indicates that the current zone database could not be converted to reflect the PID format change.
Most likely this is caused by the size of the zone database.
Recommended Change the PID format back to its original format. Reduce the size of the zone database. Retry the
Action IPD format change operation.
Severity WARNING

ZONE-1031

Message
<timestamp>, [ZONE-1031], <sequence-number>,, ERROR, <system-name>, Switch is in
interop mode. (switch, port) members not supported.
Probable Cause Indicates the switch is set to interop mode using the interopMode command. Interop mode does
not allow D,I members in the active zone database.
Recommended Remove all D,I members from the zone database, or convert them to WWN zoning.
Action
Severity ERROR

ZONE-1032

Message
<timestamp>, [ZONE-1032], <sequence-number>,, ERROR, <system-name>, Domain
<domain number> Max Zone DB size <max zone db size>.
Probable Cause Indicates that the specified domain does not have enough memory for the zone database being
committed.
Recommended Reduce the size of the zone database and retry the operation.
Action
Severity ERROR
760 Fabric OS Message Reference
53-1002448-01