Bm-1001; Bm-1002; Bm-1003; Bm System Messages - Brocade Communications Systems SN3000B Reference

BM System Messages

BM-1001

Message
<timestamp>, [BM-1001], <sequence-number>,, ERROR, <system-name>, BM protocol
version <Protocol version> in slot <Slot number>.
Probable Cause Indicates that the firmware running on the control processor (CP) cannot communicate with the
application processor (AP) blade in the indicated slot and determine the AP blade's firmware
version.
•
•
Recommended The problem can be corrected by changing the firmware version on either the control processor
Action (CP) or on the application processor (AP) blade. You can modify the firmware version on the CP
blade by using the firmwareDownload command. Refer to the release notes to determine whether a
non-disruptive firmware download is supported between the revisions. Because the AP and CP
blades cannot communicate, it is not possible to load new firmware on the AP blade. If needed,
send the AP blade back to the factory for a firmware update.
Severity ERROR

BM-1002

Message
<timestamp>, [BM-1002], <sequence-number>,, INFO, <system-name>, Connection
established between CP and blade in slot <Slot number>
Probable Cause Indicates the control processor (CP) has established a connection to the blade processor (BP) and
can communicate.
Recommended No action is required as this is the expected behavior.
Action
Severity INFO

BM-1003

Message
<timestamp>, [BM-1003], <sequence-number>, FFDC, WARNING, <system-name>, Failed
to establish connection between CP and blade in slot <Slot number>. Faulting
blade.
Probable Cause Indicates the control processor (CP) could not establish a connection with the blade processor (BP)
to communicate.
Fabric OS Message Reference
53-1002448-01
The CP blade is running a later version of firmware than the AP blade.
The CP blade is running an earlier version of firmware than the AP blade.
Chapter
10
.
91