Cdr-1001; Cdr-1002; Cdr-1003; Cdr System Messages - Brocade Communications Systems SN3000B Reference

CDR System Messages

CDR-1001

Message
<timestamp>, [CDR-1001], <sequence-number>,, ERROR, <system-name>, Port<port
number> port fault. Please change the SFP or check cable.
Probable Cause Indicates a deteriorated small form-factor pluggable (SFP), an incompatible SFP pair, a faulty cable
between peer ports, or that the port speed configuration does not match the capability of the SFP.
Recommended Ensure that you are using compatible SFPs on the peer ports.
Action
Verify whether the SFPs have not deteriorated and the Fibre Channel cable is not faulty. Replace
the SFPs or cable, if necessary.
Severity ERROR

CDR-1002

Message
<timestamp>, [CDR-1002], <sequence-number>, FFDC, ERROR, <system-name>, Port
<port number> chip faulted due to internal error.
Probable Cause Indicates an internal error.
Recommended For a bladed system, execute the slotPowerOff and slotPowerOn commands on the blade to recover
Action the system. For a non-bladed system, perform fastBoot command on the switch to recover the
system.
Severity ERROR

CDR-1003

Message
<timestamp>, [CDR-1003], <sequence-number>,, WARNING, <system-name>, S<slot
number>, C<chip index>: HW ASIC Chip error type = 0x<chip error type>. If the
problem persists, blade may need to be reset or replaced.
Probable Cause Indicates an internal error in the Application Specific Integrated Circuit (ASIC) hardware that may
degrade data traffic.
Recommended Whenever this error occurs, restart the system at the next maintenance window. If the problem
Action persists, replace the blade.
Severity WARNING
Fabric OS Message Reference
53-1002448-01
Chapter
15
115