Bl-1046; Bl-1047; Bl-1048; Bl-1049 - Brocade Communications Systems SN3000B Reference

7

BL-1046

BL-1046
Message
<timestamp>, [BL-1046], <sequence-number>,, ERROR, <system-name>, <Slot number of
blade that has the SFP> error on SFP in Slot <Port number into which the SFP is
inserted>/Port <The type of error "checksum" or "data access" for general problems
accessing the i2c accessible data> (<A detailed error code>). Try reseating or
replacing it.
Probable Cause Indicates the checksum in an area on the SFP does not match with the computed one or there is
problem accessing the data.
Recommended Try reseating the SFP, if problem persists replace it.
Action
Severity ERROR

BL-1047

Message
<timestamp>, [BL-1047], <sequence-number>,, INFO, <system-name>, Buffer optimized
mode is turned <buffer optimized mode> for slot <slot number>.
Probable Cause Indicates the buffer optimized mode is changed for the slot.
Recommended No action is required.
Action
Severity INFO

BL-1048

Message
<timestamp>, [BL-1048], <sequence-number>,, WARNING, <system-name>, FCoE Blade in
slot <Slot> failed because the Interop mode is enabled on the switch.
Probable Cause Indicates that the interop mode is turned on in the default switch while powering on the FCoE
blade.
Recommended Try turning off the interop mode using the interopmode command. Then execute the slotPowerOff
Action and slotPowerOn commands on the FCoE blade.
Severity WARNING

BL-1049

Message
<timestamp>, [BL-1049], <sequence-number>,, INFO, <system-name>, Serdestunemode
is turned <serdestuning mode>.
Probable Cause Indicates that the serdestunemode is changed for the slot.
84 Fabric OS Message Reference
53-1002448-01