Configuration > Dhcp Relay > Dhcp Relay Global Settings - D-Link DGS-2000 Series Reference Manual

4 Web-based Switch Configuration
Daylight Saving Time State: Enable or disable the DST Settings.
Daylight Saving Time Offset: Use this drop-down menu to specify the amount of time that will constitute the
local DST offset - 30, 60, 90, or 120 minutes.
Time Zone Offset GMT +/- HH:MM: Use these drop-down menus to specify the local time zone's offset from
Greenwich Mean Time (GMT.)
DST Repeating Settings:
From: Which Week of the Month: Enter the Week of Month will start on, each year.
From: Day of the Week: Enter the Day DST will start on, each year.
From: Month: Enter the month DST will start on, each year.
From: Time In HH:MM: Enter the time of day that DST will start on, each year.
To: Which Week of the Month: Enter the Week of Month will end on, each year.
To: Day of the Week: Enter the day of week that DST will end on, each year.
To: Month: Enter the month DST and date DST will end on, each year.
To: Time In HH:MM: Enter the time of day that DST will end on, each year.
DST Annual Settings:
From: Month / Day: Enter the month DST and date DST will start on, each year.
From: Time In HH:MM: Enter the time of day that DST will start on, each year.
To: Month / Day: Enter the month DST and date DST will end on, each year.
To: Time HH:MM: Enter the time of day that DST will end on, each year.
Click Apply to make the configurations take effect.
Configuration > DHCP Relay > DHCP Relay Global Settings
User can enable and configure DHCP/BOOTP Relay Global Settings on the Switch.
Figure 4.81 - Configuration > DHCP Relay > DHCP Relay Global Settings
Parameters
DHCP Relay State
DHCP Relay Hops Count Limit
(1-16)
DHCP Relay Time Threshold
(0-65535)
Descriptions
This field can be toggled between Enabled and Disabled using the
pull-down menu. It is used to enable or disable the DHCP/BOOTP
Relay service on the Switch. The default is Disabled.
This field allows an entry between 1 and 16 to define the maximum
number of router hops DHCP/BOOTP messages can be forwarded
across. The default hop count is 4.
Allows an entry between 0 and 65535 seconds, and defines the
maximum time limit for routing a DHCP/BOOTP packet. If a value
of 0 is entered, the Switch will not process the value in the
6 6 3 3
D-Link DGS-2000 Series Ethernet Switch User Manual