Defining Line Passwords
1. Open the Line Password page.
2. Select device access through a Console, Telnet, or Secure Telnet (SSH) session.
3. Define the Line Password field for the type of session you use to connect to the device.
4. Confirm the Line Password.
5. Click Apply Changes.
The line password for the type of session is defined, and the device is updated.
Assigning Line Passwords Using CLI Commands
For information about the CLI commands that perform this function, see the AAA Commands chapter
CLI Reference Guide
in the
Table 6-28. Line Passwords Commands
CLI Command
password
Enable Password
Use the Enable Password page to set a local password to control access to normal and privilege levels.
To display the Enable Password page, click System → Management Security → Enable Password in the
tree view.
Figure 6-50. Enable Password
The Enable Password page contains the following fields:
162
Configuring System Information
. The following table summarizes the equivalent CLI commands you use.
Description
Specifies the password for a line (console, telnet, or SSH).