Radius Accounting Server Configuration - Dell PowerConnect 8024 User Manual

Figure 6-57. RADIUS Server Status
3. To remove a named server, select the check box in the Remove column.
4. Click Apply Changes.
The RADIUS server is removed from the list.
Configuring RADIUS Server Settings Using CLI Commands
For information about the CLI commands that perform this function, see the RADIUS Commands
CLI Reference Guide
chapter in the
use.
Table 6-32. RADIUS Server Commands
CLI Command
auth-port
key
msgauth
name
primary
radius-server host
show radius-servers

RADIUS Accounting Server Configuration

From the RADIUS Accounting Server Configuration page, you can add a new RADIUS accounting
server, configure settings for a new or existing RADIUS accounting server, and view RADIUS accounting
server status information. The RADIUS client on the switch supports up to 32 named authentication
and accounting servers.
To access the RADIUS Server Configuration page, click System → Management Security → RADIUS
Accounting Server Configuration in the tree view.
172
Configuring System Information
. The following table summarizes the equivalent CLI commands you
Description
Sets the port number for authentication requests of the designated
radius server.
Sets the authentication and encryption key for all RADIUS
communications between the switch and the RADIUS daemon.
Enables the message authenticator attribute to be used for the
RADIUS Authenticating server being configured.
Assigns a name to a RADIUS server.
Specifies that a configured server should be the primary server in the
group of authentication servers which have the same server name.
Specifies a RADIUS server host and enter RADIUS Configuration
mode.
Displays the RADIUS server settings.