3. Select a Host Name Mapping Table entry.
4. Check the Remove check box.
5. Click Apply Changes.
The Host Name Mapping Table entry is removed, and the device is updated.
Mapping an IP Address to Domain Host Names Using CLI Commands
For information about the CLI commands that perform this function, see the IP Addressing Commands
CLI Reference Guide
chapter in the
use.
Table 6-18. Host Name Mapping Command
CLI Command
ip host
Dynamic Host Name Mapping
Use the Dynamic Host Name Mapping page to view dynamic host entries the switch has learned.
To display the Dynamic Host Name Mapping page, click System → IP Addressing → Dynamic Host
Name Mapping in the tree view.
Figure 6-29. Dynamic Host Name Mapping
The Dynamic Host Name Mapping page contains the following fields:
Host Name — Contains a list of host names.
•
•
Total Time — Total time of the dynamic entry.
•
Elapsed Time — Elapsed time of the dynamic entry.
•
Address — IP address of dynamic entry.
•
Remove — Select the entry to remove from the table, and then click Apply Changes to remove the
selected entry from the Host Name IP Mapping list.
136
Configuring System Information
. The following table summarizes the equivalent CLI commands you
Description
Use to configure static host name-to-address mapping in the host
cache.