Dell PowerConnect 8024 User Manual page 204

Figure 6-85. CP - Client Status
The CP - Client Status page contains the following fields:
• Configuration Name — The drop-down menu lists each CP configured on the switch. To view
information about the clients connected to the CP configuration, select the CP configuration name
from the list.
• MAC Address — Identifies the MAC address of the client.
• IP Address — Identifies the IP address of the client.
Interface — Identifies the interface the client used to access the network.
•
• Protocol — Shows the current connection protocol, which is either HTTP or HTTPS.
• Verification — Shows the current account type, which is Guest, Local, or RADIUS.
Configuring Captive Portal Settings Using CLI Commands
For information about the CLI commands that perform this function, see the Captive Portal Commands
CLI Reference Guide
chapter in the
use to configure Captive Portal.
Table 6-40. Captive Portal Configuration Commands
CLI Command
authentication timeout
captive-portal
http port
https port
show captive-portal
show captive-portal status
block
204
Configuring System Information
. The following table summarizes the equivalent CLI commands you
Description
Configures the authentication timeout.
Enables the captive portal configuration mode.
Configures an additional HTTP port for captive portal to monitor.
Configures an additional HTTPS port for captive portal to monitor.
Displays the status of captive portal.
Reports the status of all captive portal instances in the system.
Blocks all traffic for a captive portal configuration.