Dell PowerConnect 8024 User Manual page 737

Figure 12-21. IGMP Proxy Interface Membership Info
The IGMP Proxy Interface Membership Info page displays the following fields:
• Interface — Displays the interface on which IGMP proxy is enabled.
Multicast Group IP — Select the IP multicast group address for which data is to be displayed. If no
•
group membership reports have been received on the selected interface you cannot make this
selection, and none of the following data displays.
• Last Reporter — The IP address of the source of the last membership report received for the IP
Multicast group address on the IGMP Proxy interface.
• Up Time (secs) — The time elapsed since this entry was created.
• State — The state of the host entry. A Host can be in one of the state. Non-member state - does not
belong to the group on the interface. Delaying member state - host belongs to the group on the
interface and report timer running. The report timer is used to send out the reports. Idle member state
- host belongs to the group on the interface and no report timer running.
• Number of Sources — The number of source hosts present in the selected multicast group.
Displaying IGMP Proxy Interface Membership Info Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• IGMP Proxy Commands
The following table summarizes the equivalent CLI commands for this feature.
Configuring IP Multicast
737