Ospfv3 Configuration - Dell PowerConnect 8024 User Manual

OSPFv3 Configuration

Use the OSPFv3 Configuration page to activate and configure OSPFv3 for a switch.
To display the page, click IPv6 → OSPFv3 → Configuration in the tree view.
Figure 10-15. OSPFv3 Configuration
The OSPFv3 Configuration page contains the following fields:
• Router ID — The 32-bit integer in dotted decimal format that uniquely identifies the router within
the autonomous system (AS). If you want to change the Router ID you must first disable OSPFv3.
After you set the new Router ID, you must re-enable OSPFv3 to have the change take effect. The
default value is 0.0.0.0, although this is not a valid Router ID, and must be changed before you press
the Apply Changes button.
• OSPFv3 Admin Mode — Select Enable or Disable from the drop-down menu. If you select Enable,
OSPFv3 is activated for the switch. The default value is Enable. You must configure a Router ID before
OSPFv3 becomes operational. This can also be done by issuing the CLI command, router-id, in
the IPv6 router OSPF mode.
NOTE: Once OSPFv3 is initialized on the router, it remains initialized until the router is reset.
625
Configuring IPv6