Dell PowerConnect 8024 User Manual page 692

Figure 11-18. Interface Configuration
The Interface Configuration page contains the following fields:
• Interface — Selects the interface to be affected by the Interface Shaping Rate. Select Unit/Port, or
LAG to be affected from the drop-down menu. Select Global to specify all interfaces.
• Interface Shaping Rate — Sets the cap on how much traffic can leave a port. The specified value
represents the maximum negotiated bandwidth in kilobit per second (Kbps). The range is 0 - Infinity
or 64 to 4294967295 kbps.
• Restore to Defaults — Restores the default interface shaping rate to the selected interfaces when
checked.
Defining Interface Configuration
1. Open the Interface Configuration page.
2. Select the unit and port or LAG to be affected, or select Global to apply the settings to all interfaces.
3. Enter an Interface Shaping Rate to apply to these ports.
4. Click Apply Changes.
The new Interface Shaping Rate is applied to the selected interface(s) and the device is updated.
Restoring Default Shaping Rate
1. Open the Interface Configuration page.
2. Click the Restore to Defaults check box.
3. Click Apply Changes.
All ports are restored to the default shaping rate, and the device is updated.
692
Configuring Quality of Service