Mld Proxy Configuration Summary - Dell PowerConnect 8024 User Manual

Interface — Select the interface for which data is to be displayed or configured from the menu. You
•
must have configured at least one router interface before configuring or displaying data for an MLD
Proxy interface and it should not be a MLD routing interface.
• Interface Mode — Select enable or disable from the menu to set the administrative status of MLD
Proxy on the selected interface. The default is disable. Routing, MLD and Multicast global admin
modes should be enabled to enable MLD Proxy interface mode.
• Unsolicited Report Interval — Enter the unsolicited time interval value in seconds. The Unsolicited
Report Interval is the time between repetitions of a host's initial report of membership in a group. Valid
values are from (1 to 260). The default value is 1.
Click Apply Changes to send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
Configuring MLD Proxy Global Settings Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• IPv6 Routing Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 12-28. IPv6 MLD Proxy Global Commands
CLI Command
ipv6 mld-proxy
ipv6 mld-proxy reset-status
ipv6 mld-proxy unsolicit-rprt-interval

MLD Proxy Configuration Summary

Use the MLD Proxy Configuration Summary page to view configuration and statistics on MLD proxy-
enabled interfaces. To display this page, click IPv6 Multicast → MLD → Proxy Interface → Configuration
Summary in the navigation tree.
750
Configuring IP Multicast
Description
Enables MLD Proxy on the router.
Resets the host interface status parameters of the MLD Proxy router.
Sets the unsolicited report interval for the MLD Proxy router.