Assigning Ports To Lags And Lacps Using Cli Commands; Lag Hash Configuration - Dell PowerConnect 8024 User Manual

Assigning Ports to LAGs and LACPs Using CLI Commands

For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Port Channel Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-35. LAG Membership Commands
CLI Command
channel-group

LAG Hash Configuration

Use the LAG HASH algorithm to set the traffic distribution mode on the aggregator link. You can set the
HASH type for each trunk.
To display the LAG Hash Configuration page, click Switching → Link Aggregation → LAG Hash
Configuration in the tree view.
Figure 7-71. LAG Hash Configuration
The LAG Hash Configuration page contains the following fields:
• LAG — The drop-down menu lists the LAG numbers.
• Hash Algorithm Type — The HASH algorithm for unicast traffic flows can be one of the following
types:
– Source MAC, VLAN, EtherType, SourceModule and Port Id
– Destination MAC, VLAN, EtherType, SourceModule and Port Id
Description
Associates a port with a port-channel.
Configuring Switching Information
369