Dell PowerConnect 8024 User Manual page 296

Assigning an ACL to an Interface
1. Open the ACL Bind Configuration page.
2. In the Interface field, specify the Unit and Port, LAG, or VLAN to configure.
3. Select the IP, IPv6, or MAC ACL in the Select an ACL field.
NOTE: Whenever an ACL is assigned on a port, LAG, or VLAN, flows from that ingress interface that do not
match the ACL are matched to the default rule, which is Drop unmatched packets.
4. Specify the priority in Assign ACL Priority.
5. Click Apply Changes.
The ACL is attached to the specified interface(s).
Removing an Interface from an ACL
1. Open the ACL Bind Configuration page.
2. Click Show All.
3. In the Interface field, specify the Unit and Port, LAG, or VLAN to view the ACL bindings for that
interface.
4. Select the Remove check box for one or more ACLs to remove.
5. Click Apply Changes.
The specified ACL(s) are removed from the interface.
Assigning ACL Membership Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
• ACL Commands
The following table summarizes the equivalent CLI commands you use to bind an IPv6 ACL to an
interface or VLAN ID.
Table 7-10. IPv6 ACL Bind Configuration Commands
CLI Command
ipv6 traffic-filter
ip access-group
296
Configuring Switching Information
:
Description
This command either attaches a specific IPv6 Access Control List
(ACL) to an interface or associates it with a VLAN ID in a given
direction.
Applies an IP based egress ACL on an Ethernet interface or a group of
interfaces.