Figure 9-57. Loopbacks Configuration - IPv6 Entry
5. Choose IPv6 from the drop-down box in the Protocol field.
6. Add the IPv6 Address.
7. Enter desired values in the remaining fields.
8. Click Submit.
The new loopback is saved, and the device is updated.
Configuring an Existing Loopback
1. Open the Loopback Configuration page.
2. Specify the loopback to configure in the Loopback drop-down menu.
3. Change field values as desired in the remaining fields.
4. Click Apply Changes.
The new configuration is saved, and the device is updated.
Removing a Loopback
1. Open the Loopback Configuration page.
2. Specify the loopback to remove in the Loopback drop-down menu.
3. Click Delete Loopback.
The loopback is deleted, and the device is updated.
Removing a Secondary Address
1. Open the Loopback Configuration page.
592
Configuring Routing