LAGs — Displays and assigns multicast group membership to LAGs. To assign membership, click in
•
Static for a specific LAG. Each click toggles between S, F, and blank. See the following table for
definitions.
The following table contains definitions for port/LAG IGMP management settings.
Table 7-39. Port/LAG IGMP Management Settings
Port Control
Definition
D
Dynamic: Indicates that the port/LAG was dynamically joined to the Multicast group
(displays in the
S
Static: Attaches the port to the Multicast group as a static member in the
Displays in the
F
Forbidden: Indicates that the port/LAG is forbidden entry into the Multicast group in the
Static
Blank
Blank: Indicates that the port is not attached to a Multicast group.
Adding Bridge Multicast Addresses
1. Open the Bridge Multicast Group page.
2. Click Add.
The Add Bridge Multicast Group page displays.
Figure 7-75. Add Bridge Multicast Group
Current
row).
Current
row once Apply Changes is clicked.
Current
row. Displays in the
row once Apply Changes is clicked.
Configuring Switching Information
Static
row.
375