Dell PowerConnect 8024 User Manual page 530

The related virtual link data displays.
3. Click Delete.
The virtual link is removed, and the device is updated.
Configuring Virtual Link Data Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• OSPF Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-15. OSPF Virtual Link Commands
CLI Command
area virtual-link
area virtual-link authentication
area virtual-link dead-interval
area virtual-link hello-interval
area virtual-link retransmit-interval
area virtual-link transmit-delay
show ip ospf virtual-link
530
Configuring Routing
Description
Creates the OSPF virtual interface for the specified area-id and
neighbor router.
Configures the authentication type and key for the OSPF virtual
interface identified by the area ID and neighbor ID.
Configures the dead interval for the OSPF virtual interface on the
virtual interface identified by area-id and neighbor router.
Configures the hello interval for the OSPF virtual interface on the
virtual interface identified by the area ID and neighbor ID.
Configures the retransmit interval for the OSPF virtual interface on
the virtual interface identified by the area ID and neighbor ID.
Configures the transmit delay for the OSPF virtual interface on the
virtual interface identified by the area ID and neighbor ID.
Displays the OSPF Virtual Interface information for a specific area and
neighbor.