Viewing DHCP Relay Statistics With CLI Commands
For information about the CLI commands that perform this function, refer to the following chapter in
CLI Reference Guide
the
•
L2 DHCP Relay Agent Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-74. DHCP Relay Statistics Configuration Command
CLI Command
show dhcp l2relay stats
clear dhcp l2relay statistics
DHCP Relay VLAN Configuration
You can enable L2 DHCP relay on a particular VLAN. The VLAN is identified by a service VLAN ID (S-
VID), which a service provider uses to identify a customer's traffic while traversing the provider network
to multiple remote sites. The switch uses the VLAN membership of the switch port client (the customer
VLAN ID, or C-VID) to perform a lookup a corresponding S-VID.
If the S-VID is enabled for DHCP Relay, then the packet can be forwarded. If the C-VID does not
correspond to an S-VID that is enabled for DHCP Relay, then the switch will not relay the DHCP request
packet.
To access this page, click Switching → DHCP Relay → VLAN Configuration in the tree view.
448
Configuring Switching Information
:
Description
Displays statistics for L2 DHCP relay.
Clears all dhcp L2 relay statistics.