Configuring MLD Snooping with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
•
IPv6 MLD Snooping Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-46. MLD Snooping Commands
CLI Command
ipv6 mld snooping immediate-leave
ipv6 mld snooping groupmembership-
interval
ipv6 mld snooping maxresponse
ipv6 mld snooping mcrtexpiretime
ipv6 mld snooping (Global)
ipv6 mld snooping (Interface)
ipv6 mld snooping (VLAN)
show ipv6 mld snooping
show ipv6 mld snooping groups
MLD Snooping Global Querier Configuration
Use the MLD Snooping Global Querier Configuration page to configure the parameters for the MLD
Snooping Querier.
To display the Global Querier Configuration page, click Switching → Multicast Support → MLD
Snooping → Global Querier Configuration in the tree view.
392
Configuring Switching Information
Description
Enables or disables MLD Snooping immediate-leave admin mode on a
selected interface or VLAN.
Sets the MLD Group Membership Interval time on a VLAN or
interface.
Sets the MLD Maximum Response time for an interface or VLAN.
Sets the Multicast Router Present Expiration time.
Enables MLD Snooping on the system (Global Config Mode).
Enables MLD Snooping on an interface.
Enables MLD Snooping on a particular VLAN and all interfaces
participating in that VLAN.
Displays MLD Snooping information.
Displays the MLD Snooping entries in the MFDB table.