Multicast Admin Boundary Summary; Multicast Static Mroute Configuration - Dell PowerConnect 8024 User Manual

Multicast Admin Boundary Summary

Use the Multicast Admin Boundary Summary page to display existing administratively scoped
boundaries.
To display the page, click IPv4 Multicast → Multicast → Admin Boundary Summary in the tree view.
Figure 12-5. Multicast Admin Boundary Summary
The Multicast Admin Boundary Summary page displays the following fields:
Interface — The router interface to which the administratively scoped address range is applied.
•
• Group IP — The multicast group address for the start of the range of addresses to be excluded.
• Group Mask — The mask that is applied to the multicast group address. The combination of the mask
and the Group IP gives the range of administratively scoped addresses for the selected interface.
Displaying the Multicast Admin Boundary Summary Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Multicast Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 12-5. Multicast Admin Boundary Summary Command
CLI Command
show ip mcast boundary

Multicast Static MRoute Configuration

Use the Multicast Static MRoute Configuration page to configure a new static entry in the Mroute
table or to modify an existing entry.
Description
Displays the system-wide multicast information.
Configuring IP Multicast
709