Dell PowerConnect 8024 User Manual page 533

Figure 9-19. OSPF Route Redistribution Configuration
The OSPF Route Redistribution Configuration page contains the following fields:
Source — A protocol configured for OSPF to redistribute the routes learned through this protocol.
•
Only source routes that have been configured for redistribution by OSPF are available. Possible values
are Static, Connected, and RIP.
• Metric — Sets the metric value for redistributed routes. This field displays a metric value if the source
was preconfigured. The valid values are 0 to 16777214.
Metric Type — Select the OSPF metric type of redistributed routes from the drop-down menu.
•
• Tag — Sets the tag field in routes redistributed. This field displays a tag value if the source was
preconfigured, otherwise 0 is displayed. The valid values are 0 to 4294967295.
• Subnets — Select whether the subnetted routes should be redistributed or not from the drop-down
menu.
• Distribute List — Selects the Access List that filters the routes to be redistributed by the destination
protocol. Only permitted routes are redistributed. If this command refers to a non-existent access list,
all routes are permitted. The drop-down menu lists the ACLs configured from the Switching→
Network Security→ Access Control Lists→ IP Access Control Lists pages. When used for route
filtering, the only fields in an access list that get used are:
– Source IP Address and netmask
Configuring Routing
533