Dell PowerConnect 8024 User Manual page 682

Table 11-5. Policy Class Configuration Commands
CLI Command
assign-queue
conform-color
drop
mark cos
mark ip-dscp
mark ip-precedence
match class-map
match cos
match destination-address mac
match dstip
match dstip6
match dstl4port
match ethertype
match ip6flowlbl
match ip dscp
match ip precedence
match ip tos
682
Configuring Quality of Service
Description
Modifies the queue ID to which the associated traffic stream is
assigned.
Specifies for each outcome, the only possible actions are drop, set-cos-
transmit, set-sec-cos-transmit, setdscp-transmit, set-prec-transmit, or
transmit
Use the drop policy-class-map configuration command to specify that
all packets for the associated traffic stream are to be dropped at ingress.
Marks all packets for the associated traffic stream with the specified
class of service value in the priority field of the 802.1p header.
Marks all packets for the associated traffic stream with the specified IP
DSCP value.
Marks all packets for the associated traffic stream with the specified IP
precedence value.
Adds add to the specified class definition the set of match conditions
defined for another class.
Adds to the specified class definition a match condition for the Class
of Service value.
Adds to the specified class definition a match condition based on the
destination MAC address of a packet.
Adds to the specified class definition a match condition based on the
destination IP address of a packet.
adds to the specified class definition a match condition based on the
destination IPv6 address of a packet.
Adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword, or a numeric
notation.
Adds to the specified class definition a match condition based on the
value of the ethertype.
Adds to the specified class definition a match condition based on the
IPv6 flow label of a packet.
Adds to the specified class definition a match condition based on the
value of the IP DiffServ Code Point (DSCP) field in a packet.
Adds to the specified class definition a match condition based on the
value of the IP .
Adds to the specified class definition a match condition based on the
value of the IP TOS field in a packet.