2. Click Show All to display the Remote Log Servers Table page.
Figure 6-21. Show All Log Servers
3. To remove a server, check the corresponding Remove check box.
4. Click Apply Changes.
The server is removed, and the device is updated.
Working with Remote Server Logs Using CLI Commands
For information about the CLI commands that perform this function, see the Syslog Commands chapter
CLI Reference Guide
in the
work with remote server logs.
Table 6-14. Remote Server Logs Commands
CLI Command
logging facility
<host>
logging
Defining IP Addressing
Use the IP Addressing page to assign management interface and default gateway IP addresses, negotiate
with the Domain Name System, set a Default Domain Name, perform Host Name Mapping, and define
ARP and DHCP parameters for the interfaces.
To display the IP Addressing page, click System → IP Addressing in the tree view. Use this page to go to
the following features:
•
Out of Band Interface
•
Domain Name Server (DNS)
•
Default Domain Name
•
Host Name Mapping
•
Dynamic Host Name Mapping
130
Configuring System Information
. The following table summarizes the equivalent CLI commands you use to
Description
Use to set the facility for logging messages.
Logs messages to the specified syslog server.