Dell PowerConnect 8024 User Manual page 547

Configuring RIP
1. Open the RIP Configuration page.
2. Enter data in the fields as needed.
3. Click Apply Changes when finished.
RIP is configured, and the device is updated.
Configuring RIP Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• Routing Information Protocol (RIP) Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-24. RIP Global Configuration Commands
CLI Command
auto-summary
default-information originate
default-metric
distance rip
enable
hostroutesaccept
router rip
show ip rip
split-horizon
Description
Enables the RIP auto-summarization mode.
Controls the advertisement of default routes.
Sets a default for the metric of distributed routes.
Sets the route preference value of RIP in the router.
Resets the default administrative mode of RIP in the router (active).
Enables the RIP hostroutesaccept mode.
Enters Router RIP mode.
Displays information relevant to the RIP router.
Sets the RIP split horizon mode.
Configuring Routing
547