Protected Port Configuration - Dell PowerConnect 8024 User Manual

The following table summarizes the equivalent CLI commands for this feature.
Table 7-12. Port Configuration Commands
CLI Command
description
duplex
interface ethernet
interface range ethernet
mtu
negotiation
speed
show interfaces advertise
show interfaces configuration
show interfaces description
show interfaces detail
show interfaces status
shutdown

Protected Port Configuration

Use the Protected Port Configuration page to specify a Layer 2 security feature, Private VLAN Edge
(PVE) ports, that provides port-based security between ports that are members of the same VLAN.
Traffic from protected ports is sent only to the uplink ports and cannot be sent to other ports within the
VLAN.
To display the Port Configuration page, click Switching → Ports → Protected Port Configuration in the
tree view.
302
Configuring Switching Information
Description
Adds a description to an interface.
Configures the full/half-duplex operation of a given Ethernet interface
when not using auto-negotiation.
Enters the interface configuration mode to configure an Ethernet type
interface.
Enters the interface configuration mode to configure multiple
Ethernet type interfaces.
Enables jumbo frames on an interface by adjusting the maximum size
of a packet or maximum transmission unit (MTU).
Enables auto-negotiation operation for the duplex parameters of a
given interface.
Configures the speed of a given Ethernet interface when not using
auto-negotiation.
Displays information about auto negotiation advertisement.
Displays the configuration for all configured interfaces.
Displays the description for all configured interfaces.
Displays the detail for all configured interfaces.
Displays the status for all configured interfaces.
Disables interfaces.