Tunnels Summary - Dell PowerConnect 8024 User Manual

3. Change field values as desired in the remaining fields.
4. Click Apply Changes.
The new configuration is saved, and the device is updated.
Removing a Tunnel
1. Open the Tunnels Configuration page.
2. Specify the tunnel to remove in the Tunnel drop-down menu.
3. Click Delete Tunnel.
The tunnel is deleted, and the device is updated.
Configuring a Tunnel using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Tunnel Interface Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-41. Tunnel Commands
CLI Command
interface tunnel
tunnel destination
tunnel mode ipv6ip
tunnel source

Tunnels Summary

Use the Tunnels Summary page to display a summary of configured tunnels. To display the page, click
Routing → Tunnels → Summary in the tree view.
586
Configuring Routing
Description
Enables the interface configuration mode for a tunnel.
Specifies the destination transport address of the tunnel.
Specifies the mode of the tunnel.
Specifies the source transport address of the tunnel, either explicitly or
by reference to an interface.