Dell PowerConnect 8024 User Manual page 708

User's guide

Hide thumbs Also See for PowerConnect 8024:

Table of Contents

Figure 12-4. Multicast Admin Boundary Configuration

The Multicast Admin Boundary Configuration page contains the following fields:

Interface — Select the router interface for which the administratively scoped boundary is to be

Group IP — Enter the multicast group address for the start of the range of addresses to be excluded.

The address must be in the range of 239.0.0.0 through 239.255.255.255.

Group Mask — Enter the mask to be applied to the multicast group address. The combination of the

mask and the Group IP gives the range of administratively scoped addresses for the selected interface.

Configuring an Admin Boundary Using CLI Commands

For information about the CLI command that performs this function, see the following chapter in the

CLI Reference Guide:

Multicast Commands

The following table summarizes the equivalent CLI commands for this feature.

Table 12-4. Multicast Admin Boundary Configuration Command

ip mcast boundary

Configuring IP Multicast

Adds an administrative scope multicast boundary.

Show Quick Links

Table of Contents

Powerconnect 8024f