Dell PowerConnect 8024 User Manual page 518

Configuration data for this interface display.
Configuring an OSPF Interface using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• OSPF Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-11. OSPF Interface Configuration Commands
CLI Command
ip ospf area
ip ospf authentication
ip ospf cost
ip ospf dead-interval
ip ospf hello-interval
ip ospf network
ip ospf priority
ip ospf retransmit-interval
ip ospf transmit-delay
network area
passive-interface
show ip ospf interface
show ip ospf interface brief
518
Configuring Routing
Description
Enables OSPFv2 and sets the area ID of an interface.
Sets the OSPF Authentication Type and Key for the specified
interface.
Configures the cost on an OSPF interface.
Sets the OSPF dead interval for the specified interface.
Sets the OSPF hello interval for the specified interface.
Configure OSPF to treat an interface as a point-to-point rather than
broadcast interface.
Sets the OSPF priority for the specified router interface.
Sets the OSPF retransmit Interval for the specified interface.
Sets the OSPF Transit Delay for the specified interface.
Enables OSPFv2 on an interface and sets its area ID if the IP address of
an interface is covered by this network command.
Sets the interface or tunnel as passive.
Displays the information for the IFO object or virtual interface tables.
Displays brief information for the IFO object or virtual interface
tables.