Iscsi Sessions - Dell PowerConnect 8024 User Manual

Target Name — Identifies the iSCSI name of the iSCSI target. The name can be statically configured;
however, it can be obtained from iSNS or from sendTargets response. The initiator MUST present both
its iSCSI Initiator Name and the iSCSI Target Name to which it wishes to connect in the first login
request of a new session or connection.
Remove — To remove an iSCSI target from the table, select the Remove option and click Apply
Changes.
Adding an iSCSI Target
1. Open the iSCSI Targets Table page.
2. Click Add.
The Add iSCSI Table page displays:
Figure 6-130. Add iSCSI Target
3. Define the relevant fields.
4. Click Apply Changes.
5. The target is added to the iSCSI targets table, and the device is updated.
Viewing the iSCSI Targets Table and adding Static iSCSI Targets Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• iSCSI Commands.

iSCSI Sessions

Use the iSCSI Sessions page to view information about the iSCSI sessions that the switch has
discovered. An iSCSI session occurs when an iSCSI initiator and iSCSI target communicate over one or
more TCP connections. The maximum number of iSCSI session is 192.
To access the iSCSI Sessions page, click System → iSCSI → Sessions in the navigation tree.
Configuring System Information
263