Ospfv3 Virtual Link Summary - Dell PowerConnect 8024 User Manual

4. Click Create.
The new link is created, and you are returned to the Virtual Link Configuration page.
Configuring a Virtual Link
1. Open the OSPFv3 Virtual Link Configuration page.
2. Select the virtual link to configure.
3. Modify the remaining fields as needed.
4. Click Apply Changes.
5. The virtual link is configured for OSPFv3, and the device is updated.
Configuring an OSPFv3 Virtual Link using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• OSPFv3 Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 10-22. OSPFv3 Virtual Link Configuration Command
CLI Command
area virtual-link
area virtual-link dead-interval
area virtual-link hello-interval
area virtual-link retransmit-interval
area virtual-link transmit-delay
show ipv6 ospf virtual-link

OSPFv3 Virtual Link Summary

Use the OSPFv3 Virtual Link Summary page to display virtual link data by Area ID and Neighbor
Router ID.
To display the page, click IPv6 → OSPFv3 → Virtual Link Summary in the tree view.
Description
Creates the OSPF virtual interface for the specified
neighbor
.
Configures the dead interval for the OSPF virtual interface on the
virtual interface identified by
Configures the hello interval for the OSPF virtual interface on the
virtual interface identified by
Configures the retransmit interval for the OSPF virtual interface on
the virtual interface identified by
Configures the transmit delay for the OSPF virtual interface on the
virtual interface identified by
Displays the OSPF Virtual Interface information for a specific area and
neighbor.
areaid
areaid neighbor
and .
areaid neighbor
and .
areaid neighbor
and .
areaid neighbor
and .
Configuring IPv6
and
651