Dell PowerConnect 8024 User Manual page 715

Figure 12-9. DVMRP Interface Configuration
The DVMRP Interface Configuration page contains the following fields:
• Interface — Select the interface for which data is to be configured. You must configure at least one
router interface before you configure a DVMRP interface.
Interface Mode — Select Enable or Disable from the drop-down menu to set the administrative mode
•
of the selected DVMRP routing interface.
• Interface Metric — Enter the DVMRP metric for the selected interface. This value is sent in DVMRP
messages as the cost to reach this network. Valid values are from 1 to 31.
Configuring a DVMRP Interface
1. Open the DVMRP Interface Configuration page.
2. Select the interface to configure from the Interface field.
3. Modify the remaining fields as needed.
4. Click Apply Changes.
The interface configuration is saved, and the device is updated.
Configuring a DVMRP Interface Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• DVMRP Commands
The following table summarizes the equivalent CLI commands for this feature.
Configuring IP Multicast
715