Dell PowerConnect 8024 User Manual page 672

Subnet Mask — The subnet mask of the destination IP address. This field is required when
•
Destination IP Address is checked.
Source L4 Port— Requires a packet's TCP/UDP source port to match the port listed here. Select one
•
of the following options:
– Select From List — Click to select from a list of well known source ports to which packets are
matched.
– Match to Port — Click to add a user-defined Port ID to which packets are matched. Range is 0-
65535.
• Destination L4 Port — Requires a packet's TCP/UDP destination port to match the port listed here.
Select one of the following:
– Select From List — Select from a list of well known destination ports to which packets are
matched.
– Match to Port — Click to add a user-defined Port ID to which packets are matched. Range is 0-
65535.
• Protocol — Requires a packet's protocol to match the protocol listed here. Select one of the following:
– Select from List — Select from the drop-down list of protocols.
Match to Protocol ID — Enter a protocol ID to which packets are matched. Range is 0-255.
–
• EtherType — Requires a frames' Ethertype to match the Ethertype listed here. Select one of the
following:
– Select from List — Select from the drop-down list of EtherTypes.
– Match to Value — Enter an Ethertype ID to which packets are matched. Range is 0600-FFFF.
• Class of Service — Requires a packet's Class of Service (CoS) for incoming packets to match the CoS
entered here. Range is 0-7.
• Source MAC Address — Requires a packet's Source MAC Address for incoming packets to match the
address entered here.
Source MAC Mask — Specifies the Source MAC address wildcard mask. Wild card masks determine
•
which bits are used and which bits are ignored. A wild card mask of 00.00.00.00.00.00 indicates that no
bit is important. A wildcard of FF:FF:FF:FF:FF:FF indicates that all bits are important. This field is
required when Source MAC Address is checked.
• Destination MAC Address — Requires a packet's Destination MAC Address for incoming packets to
match the address entered here.
• Destination MAC Mask — Specifies the Destination MAC address wildcard mask. Wild card masks
determine which bits are used and which bits are ignored. A wild card mask of 00.00.00.00.00.00
indicates that no bit is important. A wildcard of FF:FF:FF:FF:FF:FF indicates that all bits are
important. This field is required when Destination MAC Address is checked.
VLAN ID — Requires a packet's VLAN ID for incoming packets to match the VLAN ID entered here.
•
Range is 0-4095.
672
Configuring Quality of Service