2. Click the Restore Defaults check box.
3. Click Apply Changes.
Queue values are returned to their defaults, and the device is updated.
Mapping Table Configuration Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
•
QoS Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 11-8. Mapping Table Configuration Commands
CLI Command
classofservice dotlp-mapping
classofservice ip-dscp-mapping
classofservice trust
show classofservice dotlp-mapping
show classofservice ip-dscp-mapping
show classofservice trust
show interfaces cos-queue
Interface Configuration
Use the Interface Configuration page to specify ports individually for CoS configuration and to apply an
interface shaping rate to the selected ports.
To display the Interface Configuration page, click Quality of Service → Class of Service → Interface
Configuration in the tree view.
Description
Maps an 802.1p priority to an internal traffic class for a switch.
Maps an IP DSCP value to an internal traffic class.
Sets the class of service trust mode of an interface.
Displays the current Dot1p (802.1p) priority mapping to internal
traffic classes for a specific interface.
Displays the current IP DSCP mapping to internal traffic classes for a
specific interface.
Displays the current trust mode setting for a specific interface.
Displays the class-of-service queue configuration for the specified
interface.
Configuring Quality of Service
691