Configuration Procedure
n
The type of username and password of a local user must be consistent with
■
that used for MAC authentication.
All the letters in the MAC address to be used as the username and password of
■
a local user must be in lower case.
The service type of the local user must be configured as lan-access.
■
Follow these steps to configure MAC authentication:
To do...
Enter system view
Enable MAC
authentication globally
Enable MAC
authentication for
specified ports
Specify the ISP domain
for MAC authentication
Set the offline detect
timer
Set the quiet timer
Set the server timeout
timer
Configure the
username and
password for MAC
authentication
You can configure MAC authentication for various ports in advance. The
■
configuration, however, takes effect only after the global MAC authentication
is enabled.
You can neither add a MAC authentication enabled port into an aggregation
■
group, nor enable MAC authentication on a port added into an aggregation
group.
Support for the mac-authentication user-name-format command varies by
■
device.
Use the command...
system-view
mac-authentication
mac-authentication interface
interface-list
interface interface-type
interface-number
mac-authentication
quit
mac-authentication domain
isp-name
mac-authentication timer
offline-detect offline-detect-value
mac-authentication timer quiet
quiet-value
mac-authentication timer
server-timeout
server-timeout-value
mac-authentication
user-name-format { fixed
[ account name ] [ password
{ cipher | simple } password ] |
mac-address [ with-hyphen |
without-hyphen ] }
Configuring MAC Authentication
Remarks
-
Required
Disabled by default
Required
Disabled by default
Optional
The default ISP domain
(system) is used by default.
Optional
300 seconds by default
Optional
60 seconds by default
Optional
100 seconds by default
Optional
By default, the user's source
MAC address serves as the
username and password.
Whether "-" is necessary in
the MAC address varies with
device.
1805
Need help?
Do you have a question about the MSR 50 Series and is the answer not in the manual?
Questions and answers