3Com MSR 50 Series Configuration Manual page 2087

To do... Use the command...
Enter system view system-view
Enable SNMP Agent snmp-agent
Configure SNMP snmp-agent sys-info { contact
Agent system sys-contact | location sys-location |
information version { all | { v1 | v2c | v3 }* } }
Configure an SNMP snmp-agent group v3 group-name
agent group [ authentication | privacy ]
[ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ] [ acl
acl-number ]
Add a new user to an snmp-agent usm-user v3
SNMP agent group user-name group-name
[ authentication-mode { md5 |
sha } auth-password
[ privacy-mode { aes128 | des56 }
priv-password ] ] [ acl acl-number ]
Configure the snmp-agent packet max-size
maximum size of an byte-count
SNMP packet that
can be received or
sent by an SNMP
agent
Configure the switch snmp-agent local-switch fabricid
fabric ID for a local switch fabricid
SNMP agent
Create or update the snmp-agent mib-view { excluded
MIB view content for | included } view-name oid-tree
an SNMP agent [ mask mask-value ]
Follow these steps to configure SNMPv1 and SNMPv2c:
To do...
Enter system view
Enable SNMP Agent
SNMP Configuration
Remarks
-
Optional
Disabled by default
You can enable SNMP Agent
through this command or any
commands that begin with
"snmp-agent".
Optional
The defaults are as follows:
Hangzhou H3C Technology
Co.,Ltd. for contact,
Hangzhou China for location,
and SNMP v3 for the version.
Required
Required
Optional
1,500 bytes by default
Optional
Company ID and device ID by
default
Optional
MIB view name is ViewDefault
and OID is 1 by default.
Use the command...
system-view
snmp-agent
2087
Remarks
-
Optional
Disabled by default
You can enable SNMP
Agent through this
command or any
commands that begin
with "snmp-agent".