When Using Publickey Authentication - 3Com MSR 50 Series Configuration Manual

1934 C 102: SSH2.0 C
HAPTER
When Using Publickey
Authentication
ONFIGURATION
Figure 561 SSH client interface
Network requirements
The host (SSH client) and the router (SSH server) are directly connected through
■
the Ethernet interfaces.
The host runs SSH2.0 client software to securely log on to the router for
■
configuration.
Publickey authentication is used, the algorithm is RSA.
■
Network diagram
Figure 562 Network diagram for SSH server configuration (using publickey
authentication)
SSH client
192.168.1.56/24
Host
Configuration procedure
Configure the SSH server
# Generate RSA and DSA key pairs and enable SSH server.
<Router> system-view
[Router] public-key local create rsa
[Router] public-key local create dsa
[Router] ssh server enable
# Configure an IP address for interface Ethernet 1/1, which the SSH client will use
as the destination for SSH connection.
SSH server
Eth1/1
192.168.1.40/24
Router