Configuring The Collaboration Function; Configuring Trap Delivery - 3Com MSR 50 Series Configuration Manual

3com msr 30-16: software guide
Hide thumbs Also See for MSR 50 Series:
Table of Contents

Advertisement

Configuring the
Collaboration
Function
Configuring Trap
Delivery
To do...
Enter NQA test group view
Configure the test type as
DLSw and enter test type view
Configure the destination
address for a test operation
Configure the source IP
address of a probe request in
a test operation
Configure common optional
parameters
Collaboration is implemented by establishing collaboration entries to monitor the
detection results of the current test group. If the number of consecutive probe
failures reaches the threshold, the configured action is triggered.
Follow these steps to configure the collaboration function:
To do...
Enter system view
Enter NQA test group view
Enter test type view of the test
group
Create a Reaction entry
Create the Track object
associated with the specified
collaboration entry in the
NQA test group
c
CAUTION: You cannot modify the content of a collaboration object using the
reaction command after the collaboration object is created.
You can set a switch to control the delivery of the trap message to the network
management server.

Configuring the Collaboration Function

Use the command...
nqa entry admin-name
operation-tag
type dlsw
destination ip ip-address
source ip ip-address
Refer to "Configuring
Optional Parameters Common
to an NQA Test Group" on
page 2028
Use the command...
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | ftp |
http | icmp-echo | snmp |
tcp | udp-echo }
reaction item-num
checked-element probe-fail
threshold-type consecutive
occurrences [ action-type {
none | trigger-only } ]
track entry-number nqa
entry admin-name
operation-tag reaction
item-num
2027
Remarks
-
Required
Required
By default, no destination IP
address is configured for a
test operation.
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Optional
Remarks
-
-
The collaboration function is
not supported in UDP-jitter
tests.
Required
Not created by default.
Required
Not created by default.

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading
Need help?

Need help?

Do you have a question about the MSR 50 Series and is the answer not in the manual?

Table of Contents