Configuring Synchronous Information Output; Displaying And Maintaining Information Center - 3Com MSR 50 Series Configuration Manual

2148 C 119: I
HAPTER NFORMATION
Configuring
Synchronous
Information Output
Displaying and
Maintaining
Information Center
C C
ENTER ONFIGURATION
Use the info-center logfile switch-directory command to manually
■
configure the directory to which a log file can be saved. The configuration will
be invalid after system reboots or the primary/backup switchover.
Synchronous information output refers to the feature that if the user's input is
interrupted by system output such as log, trap, or debug information, then after
the completion of system output the system will display a command line prompt
(in command editing mode a prompt, or a [Y/N] string in interaction mode) and
your input so far.
This command is used in the case that your input is interrupted by a large amount
of system output. With this feature enabled, you can continue you operations
from where you were stopped.
Follow these steps to enable synchronous information output:
To do...
Enter system view
Enable synchronous
information output
n
If you do not input any information following the current command line
■
prompt, the system does not display any command line prompt after system
information output.
In the interaction mode, you are prompted for some information input. If the
■
input is interrupted by system output, no system prompt will be made, rather
only your input will be displayed in a new line.
To do...
Display channel information for a
specified channel
Display the configurations for all
information channels except channel
6 to 8
Display the state of the log buffer
and the log information recorded
Display a summary of the log buffer
Display the content of the log file
buffer
Display the configuration of the log
file
Display the state of the trap buffer
and the trap information recorded
Reset the log buffer
Reset the trap buffer
Use the command...
system-view
info-center synchronous
Use the command...
display channel
[ channel-number |
channel-name ]
display info-center
display logbuffer [ level
severity | size buffersize ] * [ |
{ begin | exclude | include }
text ]
display logbuffer summary
[ level severity ] *
display logfile buffer
display logfile summary
display trapbuffer [ size
buffersize ]
reset logbuffer
reset trapbuffer
Remarks
-
Required
Disabled by default
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view