3Com MSR 50 Series Configuration Manual page 1410

1410 C 77: MPLS TE C
HAPTER ONFIGURATION
Perform the display ip routing-table command on each router. You should see
that all nodes learnt the host routes of other nodes with LSR IDs as destinations.
Take Router A for example:
<RouterA> display ip routing-table
Routing Tables: Public
Destinations : 13
Destination/Mask
1.1.1.1/32
2.1.1.0/24
2.1.1.1/32
2.2.2.2/32
3.1.1.0/24
3.2.1.0/24
3.3.1.0/24
3.3.3.3/32
4.1.1.0/24
4.4.4.4/32
5.5.5.5/32
127.0.0.0/8
127.0.0.1/32
3 Configure MPLS TE basic capabilities, and enable CSPF
# Configure Router A.
<RouterA> system-view
[RouterA] mpls lsr-id 1.1.1.1
[RouterA] mpls
[RouterA-mpls] mpls te
[RouterA-mpls] mpls te cspf
[RouterA-mpls] quit
[RouterA] interface ethernet 1/0
[RouterA-Ethernet1/0] mpls
[RouterA-Ethernet1/0] mpls te
[RouterA-Ethernet1/0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] mpls lsr-id 2.2.2.2
[RouterB] mpls
[RouterB-mpls] mpls te
[RouterB-mpls] mpls te cspf
[RouterB-mpls] quit
[RouterB] interface ethernet 1/0
[RouterB-Ethernet1/0] mpls
[RouterB-Ethernet1/0] mpls te
[RouterB-Ethernet1/0] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] mpls
[RouterB-Ethernet1/1] mpls te
[RouterB-Ethernet1/1] quit
[RouterB] interface pos 5/0
[RouterB-POS5/0] mpls
[RouterB-POS5/0] mpls te
[RouterB-POS5/0] mpls rsvp-te
[RouterB-POS5/0] quit
Routes : 13
Proto Pre Cost
Direct 0 0
Direct 0 0
Direct 0 0
ISIS 15 10
ISIS 15 20
ISIS 15 20
ISIS 15 30
ISIS 15 20
ISIS 15 30
ISIS 15 30
ISIS 15 20
Direct 0 0
Direct 0 0
NextHop Interface
127.0.0.1 InLoop0
2.1.1.1 Eth1/0
127.0.0.1 InLoop0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
127.0.0.1 InLoop0
127.0.0.1 InLoop0